Martel Electronics BetaGauge 3II - Manual (Page 97)

Application Notes 6-12
SYS Mode
There are four methods for configuring a pressure to
electrical calibration test using SYS mode. The
following table indicates which method to use.
Use this method if…
Method 1
 Your field instrument has a pressure
output range within the ability of the
pressure module on the BetaGauge
II, and
 Your field instrument has an
electrical output range within the
ability of the DC module on the
BetaGauge II.
Method 2
 Your field instrument has a pressure
input range that exceeds the ability
of the pressure module on the
BetaGauge II, and
 Your field instrument has an
electrical output range within the
ability of the DC module on the
BetaGauge II.
Method 3
 Your field instrument has a pressure
input range within the ability of the
pressure module on the BetaGauge
II, and
 Your field instrument has an
electrical output range that exceeds
the ability of the DC module on the
BetaGauge II.