Martel Electronics BetaGauge 3II - Manual (Page 68)

5-1 Advanced Display Modes
5- Advanced Display Modes
Overview
The BetaGauge II allows you to define advanced
display modes for both the BetaPort–P pressure and
BetaPort–DC modules. This section describes how to
set up these advanced display modes.
NOTE: For information on how to use pre-
programmed display units, refer to Section 3.
Programming a User Defined Pressure
Unit
If none of the eleven (11) pre-programmed pressure
units (listed in Section 3) meet your needs, the
BetaGauge II allows you to program your own pressure
unit. Before setting up a user defined pressure unit,
make sure that the pressure module you wish to use is
installed in the module bay of your choice.
NOTE: The procedure for programming a user defined
pressure unit involves defining a label (name)
for the pressure unit. For the following
procedure, we will define an example user unit
of Feet of Water Column at 20°C.