Martel Electronics BetaGauge 3II - Manual (Page 163)

Doc. Cal. Mode 7-22
Accessing the Post-Test Status Screen
After you have calibrated the last test point for the
current tag, the BetaGauge II displays the Post-Test
Status screen. A sample is shown below:
Post-Test Status Screen Description
The Post-Test Status screen is exactly like the Tag
Status screen except for the menu items that appear at
the bottom of the screen.
NOTE: Refer to the Tag Status screen description
(earlier in this section) for a complete
description of the screen data.
From the Post Test Status screen, you can perform the
following functions:
 Use the menu items at the bottom of the screen to
indicate whether the field instrument under test was
adjusted (Yes), left alone (No), or replaced (Rep).
 Access another system prompt that allows you to
indicate the identification number of the technician
who performed the calibration. This entry is
optional.
Tag 2:
BG2 TAGS Tag 2
Inst. OUT: mA
Inst. IN:
PSI
Status: PASS
Time: 11:23:59
Date: 10/07/96
Error Tol: 0.0500
Alert Tol: 999999
Next: As Left 1
Adj. Instr.
Yes No Rep