Martel Electronics MECP100 - Manual

www.martelcorp.com
e-mail: [email protected]
Tel: (603) 434-1433 800-821-0023
Fax: (603) 434-1653
Martel Electronics
3 Corporate Park Drive
Derry, NH 03038
Rev C 1/13 P/N 0219057
MECP100
Pneumatic Hand Pump
Operating Instructions
The Martel MECP100 Hand Pump is designed to be a simple to use
pressure and vacuum source for calibrating process control
instrumentation. Combined with one of our pressure calibrators, the
MECP100 makes a complete Pressure/Vacuum Calibration System.
Operation
The drawing shows the operation of the controls on the MECP100. The
pump is designed for use with ambient air only. If there is a possibility that
contaminants may enter the pump the optional filter (Martel P/N 54-54067)
should be installed at the output fitting.
CAUTION: Do not connect the pump to a pressure source.