Martel Electronics BetaGauge 3II - Manual (Page 24)

1-9 General Description
Setup Menu
The Setup menu contains the following menu items:
Menu
Item
Allows you to …
Trip
Detect trips from either wet or dry contacts
using an installed DC module. Refer to
Section 3 for more information.
Unit Select the desired pressure units for display
when using a BetaPort–P pressure module.
Refer to Sections 3, 4, and 5 for more
information.
Damp Select the damping factor for fluctuating
inputs. Refer to Section 3 for more
information.
V/mA Select voltage or milliamp measurements
when using a BetaPort–DC module.
Sys Access the BetaGauge II’s Documenting
Calibrator (SYS) Mode. Refer to Section 7
for more information.
Owner View the owner identification, the serial
number of the calibrator, and the last factory
acceptance date of the calibrator. Refer to
Section 4 for more information.
Beep Enable or disable the keypad beep. Refer to
Section 4 for more information.
LCD Enable or disable the backlight off timeout
mechanism and change the LCD contrast.
Refer to Section 4 for more information.
Off Enable or disable the auto shut off
mechanism and set the auto shut off period.
Refer to Section 4 for more information.