Martel Electronics BetaGauge 3II - Manual (Page 63)

User Preferences 4-8
5. Use the numbers on the keypad to enter a delay
value between 200 and 3600 seconds, then press
the ENTER key to return to the Auto Off menu.
NOTE: If you attempt to enter a value outside this
range, an Invalid Entry message will
appear. To erase an existing entry or to correct a
mistake, use the CLR key to erase the character to
the left of the cursor.
6. From the Auto Off menu, press the CLR key to
return to the Setup menu.
Setting and Formatting the Time
Display
The BetaGauge II allows you to manually set the time
as well as format the time display. The calibrator time
appears in the upper left portion of the LCD.
NOTE: Instrument maintenance software packages can
set the calibrator’s real time clock according to
the computer time. The format of the time
display is not affected.
Setting the Time
To manually set the calibrator time, do the following:
1. Use the Menu key to locate the Setup menu item
Time, then press the corresponding function key to
display the Set time menu as shown below:
Set time
Sec Min Hrs