KROHNE PTIFLEX 2200 FOUNDATION FIELDBUS - Manual (Page 57)

OPERATION
4
57
OPTIFLEX 2200 C
www.krohne.com 09/2013 - 4002573201 - AD FF OPTIFLEX 2200 R01 en
PULSE_ERROR
Hardware error
R Hardware error
Setting:
Reference Pulse Lost / Level Pulse Lost / not defined / Overfill
Error / No Probe Detected / not defined
WARNING_
MAINTENANCE
Warning
(Maintenance
required)
R Warning (Maintenance required)
Setting:
Flange Pulse Lost / not defined / Snapshot not valid /
Reference Position Outside Range / Audio Signal Offset
Outside Range / Temperature Below -35°C / Temperature
Above +75°C
WARNING_OUT_OF_
SPEC
Warning (Out of
Specifications)
R Warning (Out of Specifications)
INFORMATIONAL
Information
R Information
Setting:
First Start / Epsilon R Calculation Frozen / Epsilon R value
low / Epsilon R value high / Temperature outside operating
range of Local Display / not defined
TRANSDUCER_ TRANSDUCER_ TRANSDUCER_ TRANSDUCER_
DIRECTORY DIRECTORY DIRECTORY DIRECTORY
Transducer Directory Transducer Directory Transducer Directory Transducer Directory
Entry Entry Entry Entry
R A directory that specifies the number and starting indices of
the data collections in the Transducer Block.
TRANSDUCER_ TRANSDUCER_ TRANSDUCER_ TRANSDUCER_
TYPE TYPE TYPE TYPE
Transducer Type Transducer Type Transducer Type Transducer Type
R Identifies the transducer that follows. Other
XD_ERROR XD_ERROR XD_ERROR XD_ERROR
Transducer Error Transducer Error Transducer Error Transducer Error
R One of the transducer error codes defined in section 4.7
"Block Alarm Subcodes" of the FF Transducer Specifications.
Uninitialized
Setting:
Unspecified error / General error / Calibration error /
Configuration error / Electronics Failure / Mechanical
Failure / I/O Failure / Data Integrity Error / Software Error /
Algorithm Error
Parameter Parameter Parameter Parameter
DD name Access Description and settings Initial Value