KROHNE PTIFLEX 2200 FOUNDATION FIELDBUS - Manual (Page 40)

4
OPERATION
40
OPTIFLEX 2200 C
www.krohne.com 09/2013 - 4002573201 - AD FF OPTIFLEX 2200 R01 en
TRANSDUCER_VALUE
Transducer Value
R Current value supplied by transducer. 0.0
ENABLE_DISABLE
Simulate En/Disable
RW The parameter "SW_Simulated" in RB Block must be enabled. Disabled
Setting:
Uninitialized / Disabled / Active
STATUS_OPTS STATUS_OPTS STATUS_OPTS STATUS_OPTS
Status Option Status Option Status Option Status Option
RW Options which the user may select in the block processing of
status.
Uninitialized
Setting:
Propagate Fault Forward / Uncertain if limited / BAD if
limited / Uncertain if Man.
UPDATE_EVT UPDATE_EVT UPDATE_EVT UPDATE_EVT
Update Event Update Event Update Event Update Event
This alert is generated by any change to the static data.
UNACKNOWLEDGED
Unacknowledged
RW A discrete enumeration which is set to "Unacknowledged"
when an alarm occurs, and set to "Acknowledged" by a write
from a human interface device or other entity which can
acknowledge that the alarm/event has been noticed.
Uninitialized
Setting:
Uninitialized / Acknowledged / Unacknowledged
UPDATE_STATE
Update State
R A discrete enumeration which gives an indication of whether
the alert has been reported.
Uninitialized
Setting:
Uninitialized / Reported / Not Reported
TIME_STAMP
Time Stamp
R The time when evaluation of the block was started and a
change in alarm/event state was detected that is unreported.
The time stamp value will be maintained constant until alert
confirmation has been received - even if another change of
state occurs.
Uninitialized
Setting:
MM / DD / YY (Month / Day / Year)
HH:MM:SS (Hour:Minute:Second)
STATIC_REVISION
Static Rev
R The static revision of the block whose static parameter was
changed and is being reported. It is possible for the present
value of static revision to be greater than this because static
can be changed at any time.
0
RELATIVE_INDEX
Relative Index
R The OD index of the static parameter whose change caused
this alert, minus the FB starting index. If the update event was
caused by a write to multiple parameters at the same time,
then this attribute will be zero.
0
XD_SCALE XD_SCALE XD_SCALE XD_SCALE
Transducer Scale Transducer Scale Transducer Scale Transducer Scale
RW The high and low scale values, engineering units code and
number of digits to the right of the decimal point used with the
value obtained from the transducer for a specified channel.
-
EU_100
EU at 100%
RW The engineering unit value which represents the upper end of
range of the associated block parameter.
100.0
EU_0
EU at 0%
RW The engineering unit value which represents the lower end of
range of the associated block parameter.
0.0
UNITS_INDEX
Units Index
RW Device Description units code index for the engineering unit
descriptor for the associated block value.
Depends on the
type, the device is
calibrated for
Units: Units: Units: Units:
m; cm; mm; ft; in; gal; L; ImpGal; m³; bbl; ft³; kg; t; STon; LTon
DECIMAL
Decimal
RW The number of digits to the right of the decimal point which
should be used by an interface device in displaying the
specified parameter.
0
Parameter Parameter Parameter Parameter
DD name Access Description and settings Initial Value