KROHNE PTIFLEX 2200 FOUNDATION FIELDBUS - Manual (Page 28)

4
OPERATION
28
OPTIFLEX 2200 C
www.krohne.com 09/2013 - 4002573201 - AD FF OPTIFLEX 2200 R01 en
FD_OFFSPEC_ACTIVE FD_OFFSPEC_ACTIVE FD_OFFSPEC_ACTIVE FD_OFFSPEC_ACTIVE
Offspec Active Offspec Active Offspec Active Offspec Active
R This parameter reflects the error conditions that are being detected
as active as selected for this category. It is a bit string, so that
multiple conditions may be shown.
Setting:
• (00) Check Function
• (01) Cond01
• (02) Cond02
• (03) Cond03
• (04) Cond04
• (05) Cond05
• (06) Snapshot invalid
• (07) Audio Signal Offset outside Range
• (08) Reference Position outside Range
• (09) Pulse Flange Lost
• (10) No Probe detected
• (11) Reference Lost Error
• (12) Oscillator Frequency failure
• (13) Temperature Above +75°C
• (14) Temperature Below -35°C
• (15) Overfill Warning
• (16) Level Lost warning
• (17) Temperature out of range (warning)
• (18) Local operation
• (19) Overfill Error
• (20) Level lost error
• (21) Temperature out of range Error
• (22) Converter Voltage Error
• (23) Converter ROM Error
• (24) Converter RAM Error
• (25) Converter EEPROM Error
• (26) Sensor not compatible
• (27) Internal Communication Error
• (28) Sensor Voltage Error
• (29) Sensor ROM Error
• (30) Sensor RAM Error
• (31) Sensor EEPROM Error
FD_OFFSPEC_ALM FD_OFFSPEC_ALM FD_OFFSPEC_ALM FD_OFFSPEC_ALM
Offspec Alarm Offspec Alarm Offspec Alarm Offspec Alarm
This parameter is used primarily to broadcast a change in the
associated active conditions, which are not masked, for this alarm
category to a Host System.
UNACKNOWLEDGED
Unacknowledged
RW A discrete enumeration which is set to Unacknowledged when an
alarm occurs, and set to Acknowledged by a write from a human
interface device or other entity which can acknowledge that the
alarm/event has been noticed.
Uninitialized
Setting:
Uninitialized / Acknowledged / Unacknowledged
ALARM_STATE
Alarm State
R A discrete enumeration which gives an indication of whether the
alert is active and whether it has been reported.
Uninitialized
Setting:
Uninitialized / Clear - reported / Clear - not reported / Active -
reported / Active - not reported
TIME_STAMP
Time Stamp
R The time when evaluation of the block was started and a change in
alarm/event state was detected that is unreported. The time stamp
value will be maintained constant until alert confirmation has been
received – even if another change of state occurs.
Uninitialized
Setting:
MM / DD / YY (Month / Day / Year)
HH:MM:SS (Hour:Minute:Second)
Parameter Parameter Parameter Parameter
DD name Access Description and settings Initial Value