KROHNE PTIFLEX 2200 FOUNDATION FIELDBUS - Manual (Page 24)

4
OPERATION
24
OPTIFLEX 2200 C
www.krohne.com 09/2013 - 4002573201 - AD FF OPTIFLEX 2200 R01 en
SUB_CODE
Subcode
R An enumeration specifying the cause of the alert to be reported. Other
VALUE
Value
R The value of the associated parameter at the time the alert was
detected.
Setting:
State 0...16
FD_FAIL_MAP FD_FAIL_MAP FD_FAIL_MAP FD_FAIL_MAP
Fail Map Fail Map Fail Map Fail Map
RW This parameter enables or disables conditions to be detected as
active for this alarm category.
(00)-(31)
Setting:
• (00) Check Function
• (01) Cond01
• (02) Cond02
• (03) Cond03
• (04) Cond04
• (05) Cond05
• (06) Snapshot invalid
• (07) Audio Signal Offset outside Range
• (08) Reference Position outside Range
• (09) Pulse Flange Lost
• (10) No Probe detected
• (11) Reference Lost Error
• (12) Oscillator Frequency failure
• (13) Temperature Above +75°C
• (14) Temperature Below -35°C
• (15) Overfill Warning
• (16) Level Lost warning
• (17) Temperature out of range (warning)
• (18) Local operation
• (19) Overfill Error
• (20) Level lost error
• (21) Temperature out of range Error
• (22) Converter Voltage Error
• (23) Converter ROM Error
• (24) Converter RAM Error
• (25) Converter EEPROM Error
• (26) Sensor not compatible
• (27) Internal Communication Error
• (28) Sensor Voltage Error
• (29) Sensor ROM Error
• (30) Sensor RAM Error
• (31) Sensor EEPROM Error
Parameter Parameter Parameter Parameter
DD name Access Description and settings Initial Value