AMT Datasouth AMTACCEL-5350 User Manual

Page 79

User's Guide

Control Panel 4-17

Select Power-On Default Settings

DFALT lets you select the printer settings to use as the power-on default
settings. You can select the factory settings or the settings you saved
previously with a SAVE operation. The printer keeps your DFALT
selection in non-volatile memory so it is retained when the printer is off.

You can select Fctry to use the factory settings as the power-on defaults;
or Usr 1 through Usr 5 to use the settings saved under one of these
names.

Run Printer Tests

TEST lets you run a variety of printer tests, including a memory check,
ribbon alignment test, serial loopback test, and a sensor check. If a test
is unsuccessful, an error message appears to notify you.

You can select None, which is always the default and does not perform
any test; Memory, which checks the printer memory; Ribbon, which
performs a ribbon alignment print test; Serial, which checks the serial
interface; and Sensor, which runs the sensor check. Printer tests are
described in detail in the Solving Problems section of this guide.

3) DFALT: Fctry

4) TEST:

None

SETUP

MENU