AMT Datasouth AMTACCEL-5350 - Manual (Page 38)

User's Guide
2-8 Set Up
Attaching the Power Cord
After checking the voltage select switch,
you are ready to attach the power cord.
To do so, use the following procedure:
1. Make sure the power switch is off.
2. Take the power cord and plug the three-
hole connector into the power receptacle
at the rear of the printer, as shown in
figure 2-9.
3. Plug the three-prong connector at the
other end of the power cord into a
properly grounded ac power outlet.
Figure 2-9. Attaching the Power Cord
User's Guide
2-8 Set Up
Attaching the Power Cord
After checking the voltage select switch,
you are ready to attach the power cord.
To do so, use the following procedure:
1. Make sure the power switch is off.
2. Take the power cord and plug the three-
hole connector into the power receptacle
at the rear of the printer, as shown in
figure 2-9.
3. Plug the three-prong connector at the
other end of the power cord into a
properly grounded ac power outlet.
Figure 2-9. Attaching the Power Cord