KEPCO BOP 1KW-MG Operator Manual, Firmware Ver.2.38 to 2.47 - Manual (Page 35)

BOP HIPWR 080709
1-15
configuration triples the output voltage and doubles the output current. If a series/parallel config-
uration is enabled, communication between the master BOP and those configured as slave
units occurs via the BITBUS. Refer to PAR. 2.8 for further details.
1.6.9 ENERGY RECUPERATION
The BOP is a four-quadrant device as shown in Figure 1-3. Operating as a source, it delivers
energy into a passive load, and as a sink it operates as an electronic load, absorbing and dissi-
pating energy from an active load. To minimize energy dissipation, the BOP employs energy
recuperation, where energy sinked from an active load is passed backwards through the output
circuit and the bidirectional input power factor correcting circuit to the a-c power lines, where it
becomes available for reuse. This technology allows high power levels using switch-mode tech-
nology while maintaining high efficiency and reduced size and weight.
1.7 EQUIPMENT SUPPLIED
Equipment supplied with the BOP power supply is listed in Table 1-3.
1.8 ACCESSORIES
Accessories for the BOP Power Supply are listed in Table 1-5.
1.9 SAFETY
Service must be referred to authorized personnel. Using the power supply in a manner not
specified by Kepco. Inc. may impair the protection provided by the power supply. Observe all
safety precautions noted throughout this manual (see listing on page E, preceding the Table of
Contents). Table 1-4 lists symbols used on the power supply or in this manual where applicable.
TABLE 1-3. EQUIPMENT SUPPLIED
ITEM FUNCTION PART NUMBER
Source Power Entry mating connector Mates with source power entry connector 142-0381 (Kepco) (IEC 320)
PAR/SER CONTROL - IN
mating connector Mates with PAR/SER CONTROL - IN port to allow
access to pins required for calibration 142-0488 (Kepco)
TABLE 1-4. SAFETY SYMBOLS
SYMBOL Meaning
WARNING! RISK OF ELECTRIC SHOCK!
CAUTION: REFER TO REFERENCED PROCEDURE.
WARNING
INDICATES THE POSSIBILITY OF BODILY INJURY
OR DEATH.
CAUTION
INDICATES THE POSSIBILITY OF EQUIPMENT
DAMAGE.
!