KEPCO BHK-MG 40W (Half Rack) Series - Manual (Page 29)

BHK-1/2-MG (OPR) 121313
1-13
1.5 EQUIPMENT SUPPLIED
Equipment supplied with the unit is listed in Table 1-4.
1.6 ACCESSORIES
Accessories for the BHK Power Supply are listed in Table 1-5.
TABLE 1-4. EQUIPMENT SUPPLIED
ITEM PART NUMBER QUANTITY
Power Cord 118-0557 1
Plug housing for front panel output jack 142-0489 1
Contact (crimp, snap-in)) for plug housing 107-0361 2
Status and Remote On/Off Port mating connector 142-0488 1
Two-terminal Link for rear panel output 172-0300 2
Three-terminal Link for rear panel output 172-0305 2
Four-terminal Link for rear panel output (installed) 172-0407 2
Five-terminal Link for rear panel output 172-0321 1
Six-terminal Link for rear panel output 172-0408 1
TABLE 1-5. ACCESSORIES
ITEM FUNCTION PART NUMBER
IEEE 488 (GPIB) Cable, 1m long Connects BHK-MG 40W Power Supply to GPIB bus. SNC 488-1
IEEE 488 (GPIB) Cable, 2m long Connects BHK-MG 40W Power Supply to GPIB bus. SNC 488-2
IEEE 488 (GPIB) Cable, 4m long Connects BHK-MG 40W Power Supply to GPIB bus. SNC 488-4
Rack Adapter Allows rack mounting of two units side by side (see Figure 1-3). RA 24
Slide (2) Allows rack-mounted units to slide in and out. CS-01, -02, -03
(Kepco)
110-QD-20-2, 22-2,
22-4 (Jonathan)
External Trigger Port mating
connector Allows access to external trigger function 142-0486 (Kepco)
MDP-023 (Power
Dynamics)
RS 232 Port Adapter Cable Kit Contains RJ 45 Patch cord, two RS 232 adapters (one with male
pins to connect to DTE equipment and one with female pins to con-
nect to a personal computer), and an RS 232 Loop Back test Con-
nector (to test RS 232 communication and aid in isolating RS 232
communication problems). KIT 219-0436
Mating connector for A2J5 (Ana-
log Readback and Flags) Allow user access to analog readback and flag signal; see Table 1-3
for details. 143-0359