14 program subsystem – GW Instek APS-1102 LabVIEW Driver User Manual User Manual

Page 35

2.14 PROGram Subsystem

2-27

2.14 PROGram subsystem

GW APS-1102 PROG Exec.vi
This controls sequence operations. Control is performed using the STOP (stop), START (run),

HOLD (hold), BRANCH0 (branch 0), or BRANCH1 (branch 1) parameter.

When in AC-EXT, AC-SYNC, AC+DC-EXT, or AC+DC-SYNC mode, sequences cannot be executed.

([3,"Invalid in this mode"] error occurs.)

When output OFF, sequence execution is disabled. ([2,"Invalid with output off"] error occurs.)

Select Execute

This sets the sequence operation control status. The default setting is “STOP”.