GW Instek APS-1102 LabVIEW Driver User Manual - Manual (Page 25)

2.7 MEASure Subsystem
2-17
GW APS-1102 MEAS Volt High.vi
This returns the positive voltage peak value (AC+DC peak value) in Vpk units.
Peak High: AC+DC
This outputs the + voltage peak value (AC+DC peak value) in Vpk units.
Error
When a measurement error occurs, “True” is set.
GW APS-1102 MEAS Volt Low.vi
This returns the negative voltage peak value (AC+DC peak value) in Vpk units.
Peak Low: AC+DC
This outputs the – voltage peak value (AC+DC peak value) in Vpk units.
Error
When a measurement error occurs, “True” is set.
GW APS-1102 MEAS Volt Ave.vi
This returns the output voltage average value (AC+DC average value) in V units.
Voltage: AC+DC
This outputs the output voltage average value (AC+DC average value) in V units.
Error
When a measurement error occurs, “True” is set.