GW Instek APS-1102 LabVIEW Driver User Manual - Manual (Page 17)

2.4 VISA Initialization
2-9
When in AC-EXT, AC-ADD, AC-SYNC, AC+DC-EXT, AC+DC-ADD, or AC+DC-SYNC mode,
step execution parameter cannot be set or queried. ([3,"Invalid in this mode"] error occurs.)
Parameters
First parameter (DC voltage [V])
Range: –200.0 to 200.0 (–400.0 to 400.0)
Second parameter (DC voltage’s operation type)
Range: 0 (CONST)/1 (KEEP)/2 (SWEEP)
Third parameter (AC voltage [Vrms]/[Vpp])
Range: 0.0 to 140.0 [Vrms]/0.0 to 400.0 [Vpp]
(0.0 to 280.0 [Vrms] / 0.0 to 800.0 [Vpp])
Fourth parameter (AC voltage operation type)
Range: 0 (CONST)/1 (KEEP)/2 (SWEEP)
Fifth parameter (frequency)
Range: 1.0 to 550.0
Sixth parameter (frequency operation type)
Range: 0 (CONST)/1 (KEEP)/2 (SWEEP)
Seventh parameter (waveform)
Range: 0 (SIN)/1 (SQU)/2 to 17 (ARB1 to ARB16)
Eighth parameter (waveform operation type)
Range: 0 (CONST)/1 (KEEP)
Ninth parameter (start phase)
Range: 0.0 to 359.9
10th parameter (start phase operation)
Range: 0 (CONST)/1 (KEEP)
11th parameter (step synchronization output)
Range: 0 (00)/1 (01)/2 (10)/3 (11)
12th parameter (step synchronization output operation type)
Range: 0 (CONST)/1 (KEEP)
Query Parameter
When Read=True, outputs the parameter contents set for the APS-1102 in the
“*,*,*,*,*,*,*,*,*,*,*,*” format (* indicates the set value). When Read = False, “space” is
set.
GW APS-1102 SOUR Seq Tpar.vi
This sets the step transition parameters. The target sequence step must be in advance with
SEQ:STEP.
In the AC-EXT, AC-SYNC, AC+DC-EXT, or AC+DC-SYNC mode, the step transition parameter