GW Instek APS-1102 LabVIEW Driver User Manual - Manual (Page 18)

APS-1102 LabVIEW Driver Manual
2-10
can’t be set. ([3,"Invalid in this mode"] error occurs.)
Parameter
First parameter (step time [s]/[ms])
Range: 0.0001 to 999.9999 [s]
0.1 to 999999.9 [ms]
Second parameter (step end phase setting mode)
Range: 0 (Disabled)/1 (Enabled)
Third parameter (step end phase [deg])
Range: 0.0 to 359.9
Fourth parameter (step termination)
Range: 0 (Continue)/1 (End)/2 (Hold)
Fifth parameter (Jump step number)
Range: 0 (Next step) / 1 to 255
Sixth parameter (Jump times)
Range: 0 (Infinite)/1 to 999
Seventh parameter (branch 0)
Range: 0 (Disabled)/1 to 999
Eighth parameter (branch 1)
Range: 0 (Disabled)/1 to 999
Query Parameter
When Read=True, outputs the parameter contents set for the APS-1102 in the
“*,*,*,*,*,*,*,*,*,*,*,*” format (* indicates the set value). When Read=False, “space” is
set.
GW APS-1102 SOUR Seq Step.vi
This specifies the target step number for sequence edition. The step number specification is 1 to
255.
Step No.
This sets the target step number of the edition. The default setting is “1”.
Step
When Read=True, outputs the target step number of edition set for the APS-1102. When
Read=False, “999” is set.
GW APS-1102 SOUR Volt.vi