GW Instek APS-1102 LabVIEW Driver User Manual - Manual (Page 20)

APS-1102 LabVIEW Driver Manual
2-12
setting is “–400.0”.
Rn_set
This specifies the range to be set. The default setting is “100 V (False)”.
Output[V]
When Read = True, outputs the lower limit of the output voltage set for the APS-1102.
When Read = False, “–999.9” is set.
GW APS-1102 SOUR Volt Offs.vi
This sets the DC voltage when in AC+DC-INT, AC+DC-ADD, or AC+DC-SYNC mode.
The DC output voltage cannot be set unless the mode is AC+DC-INT, AC+DC-ADD, or
AC+DC-SYNC modes. ([3,"Invalid in this mode"] error occurs.)
Offset_Rn100V[V]
This sets the lower limit of the output voltage in the 100 V range. The default setting is
“0.0”.
Offset _Rn200V[V]
This sets the lower limit of the output voltage in the 200 V range. The default setting is
“0.0”.
Rn_set
This specifies the range to be set. The default setting is “100V (False)”.
Output[V]
When Read=True, outputs the lower limit of output DC voltage set for the APS-1102. When
Read=False, “999.9” is set.
GW APS-1102 SOUR Rang.vi
This sets the output voltage range.
The output voltage range setting is 100 V or 200 V.
However, when output is ON, output voltage cannot be changed. ([1,"Invalid with output on"] error
occurs.)
Select Range
This sets the output range. The default setting is “100”.
Query Renge
When Read = True, outputs the output range set for the APS-1102. When Read = False,
“space” is set.