GW Instek APS-1102 LabVIEW Driver User Manual - Manual (Page 26)

APS-1102 LabVIEW Driver Manual
2-18
2.8 DISPlay Subsystem
GW APS-1102 DISP Mode.vi
This selects the measurement display selection. The measurement display selection setting is RMS
(RMS value), AVG (average DC), PEAK (peak value), and HC (harmonic current) 1 to 4. The relation
between the harmonic current mode and the harmonic degree is as follows.
HC1 (1st to 10th)
HC2 (11th to 20th)
HC3 (21st to 30th)
HC4 (31st to 40th)
However, when in AC-INT mode, if the frequency is neither 50 Hz nor 60 Hz, the harmonic current
cannot be measured. ([3, “Invalid in this mode”] or [6, “Invalid in this frequency”] error occurs.)
When the measurement display selection is HC1 to HC4, the device cannot accept other commands.
([4, “Under Busy State”] error occurs.)
Select Mode
This sets the measurement display contents. The default setting is “RMS”.
Query Mode
When Read = True, outputs the measurement display contents set for the APS-1102. When
Read = False. “space” is set.