Spectra Precision ProMark Field Software - Manual (Page 23)

Engl
ish
17
When a job is open in ProMark Field, all the points contained
in that job can be seen on the map screen and the properties
of each of these points can be displayed by simply tapping on
their location. The complete list of points present in the job
can also be listed using
Menu>Job>Points.
IMPORTANT! In job files, a distinction must be made in
terms of position accuracy between RTK (real-time) projects
and post-processed projects during which collecting raw data
is required:
• In post-processed projects, the coordinates only feature
autonomous or differential GPS accuracy, whichever is
available at that time. It’s only after post-processing, and
provided the collected raw data are good quality, that
centimeter-accurate coordinates will be delivered for your
points.
• In RTK projects, the coordinates provided in the job file
are directly centimeter-accurate, as long as RTK
initialization is maintained (i.e. all position solutions are
“fixed”).
A job file may also be used to hold points you would like to
stake out. In that case, the file will usually be prepared
separately (in GNSS Solutions for example), then downloaded
to your receiver for use in ProMark Field.
Csv File Parameters
Above the table: Coordinate system used
Table columns:
Site ID
Description
Coordinates (X, Y, Z and/or Lat, Lon, Alt)
Delta X, Y, Z (ECEF)
Number of satellites
Position solution status (Autonomous, DGPS, SDGPS,
FLOAT or FIXED)
GLONASS status (Y or N)
HRMS & VRMS values
Date & time
Occupation time
Antenna height value
Antenna height measurement type (slant or not, “1” if slant)
Offsets (distance and bearing)