Brocade Fabric OS Encryption Administrator’s Guide Supporting Key Management Interoperability Protocol (KMIP) Key-Compliant Environments (Supporting Fabric OS v7.1.0) - Manual (Page 90)

72 Fabric OS Encryption Administrator’s Guide (KMIP)
53-1002747-02
Configuring encryption storage targets
2
6. Configuration Status
7. Important Instructions
Adding an encryption target
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box (Refer to Figure 6 on page 14).
2. Select a group, switch, or engine from the Encryption Center Devices table to which to add the
target, then select Group/Switch/Engine > Targets from the menu task bar.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays ( Figure 62 ).
FIGURE 62 Encryption Targets dialog box
3. Click Add.
The Configure Storage Encryption welcome screen displays ( Figure 63 ).