Brocade Fabric OS Encryption Administrator’s Guide Supporting Key Management Interoperability Protocol (KMIP) Key-Compliant Environments (Supporting Fabric OS v7.1.0) User Manual
Page 303
Fabric OS Encryption Administrator’s Guide (KMIP)
285
53-1002747-02
Brocade Encryption Switch removal and replacement
6
11. Invoke the following command to cleanup any WWN entries which are used earlier.
Admin:switch> cryptocfg --reclaim -cleanup
12. Recreate the EG with the same name as before using the following command.
Admin:switch> cryptocfg –-create –encgroup
13. Invoke configdownload from the previous uploaded configuration.
14. Enable the switch using the switchenable command.
15. Deregister both key vaults using the following command.
Admin:switch> crypocfg –-dereg –keyvault
16. Export the KAC csr to a local machine.
Admin:switch> cryptocfg --export -scp -KACcsr
17. Sign the KAC csr using the local CA on the SSKM management console.
18. Configure the user name and password.
Admin:switch> cryptocfg --reg -KAClogin primary/secondary
19. Register the signed KAC certificate on the switch.
Admin:switch> cryptocfg --reg -KACcert
20. Register the key vaults as primary and secondary. For example:
Admin:switch> cryptocfg --reg -keyvault SSKM_10 local_ca_SSKM_10.pem
10.38.145.10 primary
Admin:switch> cryptocfg --reg -keyvault SSKM_10 local_ca_SSKM_10.pem
10.38.146.10 secondary
21. If a master key is not present, restore the master key from a backed up copy. Procedures will
differ depending on the backup media used (for example, recovery smart cards, from the key
vault, from a file on the network, or a file on a USB-attached device). Refer to Chapter 2,
“Configuring Encryption Using the Management Application.”
22. Check the encryption engine (EE) state using following command to ensure that the encryption
engine is online.
Admin:switch> cryptocfg --show -localEE
23. Set the defzone as allAccess on the new Brocade Encryption Switch, so the configuration from
the Fabric is pushed to new Brocade Encryption Switch.
24. Invoke the following command on the new Brocade Encryption Switch:
Admin:switch> cfgsave
25. Reconnect the FC Cables to the new Brocade Encryption Switch.
26. Invoke the cfgsave command on any switch in that fabric. The fabric configuration from the
existing fabric is merged into the new Brocade Encryption Switch.