Rekey operations and firmware upgrades, Do not change lun configuration while rekeying, Kac certificate registration expiry – Brocade Fabric OS Encryption Administrator’s Guide Supporting Key Management Interoperability Protocol (KMIP) Key-Compliant Environments (Supporting Fabric OS v7.1.0) User Manual
Page 257

Fabric OS Encryption Administrator’s Guide (KMIP)
239
53-1002747-02
KAC certificate registration expiry
5
Allow rekey to complete before deleting a container
Do not delete a crypto container while rekey is in session or if rekey is not completed. If you want to
delete a container, use the command cryptocfg
--
show
-
rekey
–
all to display the status of rekey
sessions. If any rekey session is not 100% completed, do not delete the container. If you do delete
the container before rekey is complete, and subsequently add the LUN back as cleartext, all data
on the LUN is destroyed.
Rekey operations and firmware upgrades
All nodes in an encryption group must be at the same firmware level before starting a rekey or
first-time encryption operation. Make sure that existing rekey or first-time encryption operations
complete before upgrading any of the encryption products in the encryption group, and that the
upgrade completes before starting a rekey or first-time encryption operation.
Do not change LUN configuration while rekeying
Never change the configuration of any LUN that belongs to a CryptoTarget container/LUN
configuration while the rekeying process for that LUN is active. If you change the LUN’s settings
during manual or auto, rekeying or first-time encryption, the system reports a warning message
stating that the encryption engine is busy and a forced commit is required for the changes to take
effect. A forced commit command halts all active rekeying progresses running in all CryptoTarget
containers and corrupts any LUN engaged in a rekeying operation. There is no recovery for this type
of failure.
Recommendation for Host I/O traffic during online rekeying and first-
time encryption
You may see failed I/Os if writes are done to a LUN that is undergoing first-time encryption or
rekeying. It is recommended that host I/O operations are quiesced and not started again until
rekey operations or first-time encryption operations for the LUN are complete.
KAC certificate registration expiry
It is important to keep track as to when your signed KAC certificates will expire. Failure to work with
valid certificates causes certain commands to not work as expected. If you are using the certificate
expiry feature and the certificate expires, the key vault server will not respond as expected. For
example, the Group Leader in an encryption group might show that the key vault is connected;
however, a member node reports that the key vault is not responding.
To verify the certificate expiration date, use the following command:
openssl x509 –in signed_kac_cert.pem -dates –noout
Output:
Not Before: Dec 4 18:03:14 2009 GMT
Not After : Dec 4 18:03:14 2010 GMT
In the example above, the certificate validity is active until “Dec 4 18:03:14 2010 GMT.” After the
KAC certificate has expired, the registration process must be redone.