Adding an encryption engine to an ha cluster, Removing engines from an ha cluster, Swapping engines in an ha cluster – Brocade Fabric OS Encryption Administrator’s Guide Supporting Key Management Interoperability Protocol (KMIP) Key-Compliant Environments (Supporting Fabric OS v7.1.0) User Manual
Page 184

166
Fabric OS Encryption Administrator’s Guide (KMIP)
53-1002747-02
High availability clusters
3
Adding an encryption engine to an HA cluster
1. Log in to the group leader as Admin or FabricAdmin.
2. Enter the cryptocfg
--
add
-
haclustemember command. Specify the HA cluster name and the
encryption engine node WWN. Provide a slot number if the encryption engine is a blade. The
following example adds a Brocade FS8-18 in slot 5 to the HA cluster HAC2.
FabricAdmin:switch> cryptocfg --add -haclustermember HAC2 \
10:00:00:60:5b:03:1c:90 5
EE Node WWN: 10:00:00:60:5b:03:1c:90 5 Slot number: 5Detected
Add HA cluster member status: Operation succeeded.
3. Add another encryption engine before committing the transaction.
NOTE
You cannot add the same node to the HA cluster.
Removing engines from an HA cluster
Removing the last engine from an HA cluster also removes the HA cluster. If only one engine is
removed from the cluster, you must either add another engine to the cluster, or remove the other
engine.
1. Log in to the group leader as Admin or FabricAdmin.
2. Enter the cryptocfg
--
remove
-
haclustemember command. Specify the HA cluster name and
the encryption engine node WWN. Provide a slot number if the encryption engine is a blade.
The following example removes a Brocade FS8-18 in slot 5 from the HA cluster HAC2.
FabricAdmin:switch> cryptocfg --remove -haclustermember HAC2 \
10:00:00:60:5b:03:1c:90 5
EE Node WWN: 10:00:00:60:5b:03:1c:90 5 Slot number: 5Detected
Remove HA cluster member status: Operation succeeded.
3. Either remove the second engine or add a replacement second engine, making sure all HA
clusters have exactly two engines.
Swapping engines in an HA cluster
Swapping engines is useful when replacing hardware. Swapping engines is different from removing
an engine and adding another because when you swap engines, the configured targets on the
former HA cluster member are moved to the new HA cluster member.
1. Log in to the group leader as Admin or FabricAdmin.
2. Enter the cryptocfg
--
replace [
-
haclustermember
<
<
Sample output is shown below.
Before:
sw153168:admin> cryptocfg --show -hacluster -all
Encryption Group Name: disk_tape