Yokogawa PC-Based MX100 - Manual (Page 65)

App-1
IM MW180-01E
1
2
3
4
5
App
Index
Appendix
Appendix 1 Configuring/Removing the Firewall
Check the following before attempting to configure or remove a firewall.
• Check the internet connection status using the ping command. If the ping fails, check
the cables, hub, IP address settings, and other factors to determine the cause.
• Check that procedures performed on the software are correct.
If the problem cannot be solved after taking the above measures, it is likely that there will
be problems with the firewall settings. Configure or remove the firewall according to the
following procedure.
Note that the following procedure describes the MW100 IP Setting Software, but it
applies to the MW100 Calibration Software as well.
Appendix