Yokogawa PC-Based MX100 - Manual (Page 23)

3-4
IM MW180-01E
3.2 Settings Related to Displaying Measured,
Computed, and Thinned Data
Procedure
Changing the Display on the Waveform Display Window
Change the display settings according to the explanation is the figure below.
Switch the display group
Scale Turn ON/OFF the channel
Change the grid density
Channel number and measurement unit
Change the background
darkness
Zoom in or out
of the time axis
Switch the
display zone
Switch the active waveform
Alarm display ON/OFF
Clip display ON/OFF
Zone display area ON/OFF
Move the cursor to the
point where the alarm
changed
Switch the grid display
Changing the Display Using the Toolbar
Change the display settings according to the explanation is the figure below.
Channel number display
Show the General Display Settings window
Tag name display
Tag comment display
Switching between Absolute and Relative time
Show the waveform display window
Alarm/Mark List
Show the numeric display window
Show the window for displaying cursor values
Adding marks
Move cursor A to the left mark
Move cursor A to the right mark
Move cursor B to the left mark
Move cursor B to the right mark
Show the window for displaying statistical computation over an area