Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 62)

8-10 IM 04L31A01-01E
8.5 Removing the Terminal Assembly
WARNING
The service manual is to be used by properly trained personnel only. To avoid
personal injury, do not perform any servicing unless you are qualified to do so.
Refer to the safety precautions prior to performing any servicing. Even if
servicing is carried out according to this service manual, or by qualified
personnel, YOKOGAWA assumes no responsibility for any result occurring from
that servicing.
CAUTION
When removing the assembly, be sure to disconnect the power cable from the
outlet before doing so.
1. Remove the screws from the upper right and lower left of the two terminal
assemblies.
2. Pull out the terminal assemblies.