Yokogawa Touch Screen GP20 - Manual (Page 33)

2-19
IM 04L51B01-17EN
Commands and Responses
1
2
App
Example Set three set points on channel 0001
(measurement range: 0 to 1.0000 V). Set the
set points as follows: when the input value is 0
V, the output value is 0.0010 V; when the input
value is 0.5000 V, the output value is 0.5020
V; when the input value is 1.0000 V, the output
value is 0.9970 V.
SCalibIO,0001,Appro,3,0,10,5000,
5020,10000,9970
Description
• If p2=Off, you cannot set p3 or subsequent
parameters.
• You cannot specify set points beyond the number of
points specified by p3.
• If the AI channel input type (p2 of SRangeAI) is set
to Skip or DI, you cannot specify anything other than
p2=Off.
SMathBasic
Math Action (/MT)
Sets the basic operation of math channels.
Syntax SMathBasic,p1,p2,p3,p4
p1 Indication on computation error
+Over Display the computed
value as +Over.
-Over Display the computed
value as -Over.
p2 SUM and AVE computation when overflow
data is detected
Error Sets the computation
result to computation
error.
Skip Discards the data that
overflowed and continues
the computation.
Limit Computes by substituting
upper or lower limit
values in the data that
overflowed.
• For channels that do
not have linear scaling
specified, the upper
or lower limit of the
measuring range
• For channels that
have linear scaling
specified, the scaling
upper or lower limit
• For math channels,
the specified span
upper or lower limit.
p3 MAX, MIN, and P-P computation when
overflow data is detected
Over Computes using data that
overflowed.
Skip Discards the data that
overflowed and continues
the computation.
P4 START/STOP key action
Off Computation does not
start even when recording
starts.
Start/Stop Computation starts when
recording starts.
Reset+
Start/Stop
Computation resets and
starts when recording
starts.
Query SMathBasic?
Example Set the indication on computation error to
“+Over,” computation when overflow data is
detected to “Skip,” and start computation when
recording starts.
SMathBasic,+Over,Skip,Skip,Start/
Stop
2.4 Setting Commands