Yokogawa AXFA14G/C - Manual (Page 5)

IM 01E20C02-01E 1-1
1. INTRODUCTION
1. INTRODUCTION
This instrument has been adjusted at the factory before
shipment.
To ensure correct use of the instrument, please read
this manual thoroughly and fully understand how to
operate the instrument before operating it.
NOTE
This manual describes the hardware and soft-
ware configurations of the AXFA14 converter
and the software configuration of the AXF
integral flowmeter.
The contents of “basic operating procedures”,
“parameter description”, “operation via BRAIN
terminal (BT200)”, “operation via HART commu-
nicator”, and “actual operation” for the AXF
integral flowmeter are the same as the AXFA14,
see Chapter 5 to 9 in this manual.
For the hardware configuration of the AXF
integral flowmeter, see the user’s manual of the
AXF Integral Flowmeter/Remote Flowtube
[Hardware Edition] (IM 01E20D01-01E).
For F
OUNDATION Fieldbus protocol (Output Signal
and Communication suffix code; -F), please refer
to IM 01E20F02-01E.
For PROFIBUS PA protocol (Output Signal and
Communication suffix code; -G), please refer to
IM01E20F12-01E.
᭿ Regarding This User's Manual
• This manual should be provided to the end user.
• Before use, read this manual thoroughly to compre-
hend its contents.
• The contents of this manual may be changed
without prior notice.
• All rights are reserved. No part of this manual may
be reproduced in any form without Yokogawa's
written permission.
• Yokogawa makes no warranty of any kind with
regard to this material, including, but not limited to,
implied warranties of merchantability and suitability
for a particular purpose.
• All reasonable effort has been made to ensure the
accuracy of the contents of this manual. However,
if any errors or omissions are found, please inform
Yokogawa.
• Yokogawa assumes no responsibilities for this
product except as stated in the warranty.
• Please note that this user's manual may not be
revised for any specification changes, construction
changes or operating part changes that are not
considered to affect function or performance.
• If the customer or any third party is harmed by the
use of this product, Yokogawa assumes no responsi-
bility for any such harm owing to any defects in the
product which were not predictable, or for any
indirect damages.
NOTE
Please refer to manual IM 01E20D01-01E for
information of the AXF Remote Flowtube.
᭿ Safety and Modification Precautions
• The following general safety precautions must be
observed during all phases of operation, service, and
repair of this instrument. Failure to comply with
these precautions or with specific WARNINGS
given elsewhere in this manual violates safety
standards of design, manufacture, and intended use
of the instrument. Yokogawa assumes no liability for
the customer's failure to comply with these require-
ments. If this instrument is used in a manner not
specified in this manual, the protection provided by
this instrument may be impaired.
• Yokogawa will not be liable for malfunctions or
damage resulting from any modification made to this
instrument by the customer.
• The following safety symbol marks are used in this
user's manual and instrument.
WARNING
A WARNING sign denotes a hazard. It calls
attention to procedure, practice, condition or the
like, which, if not correctly performed or adhered
to, could result in injury or death of personnel.
CAUTION
A CAUTION sign denotes a hazard. It calls
attention to procedure, practice, condition or the
like, which, if not correctly performed or adhered
to, could result in damage to or destruction of
part or all of the product.