Handling precautions, 1 checking model andspecifications, 2 accessories – Yokogawa AXFA14G/C User Manual
Page 10: 3 storage precautions, Handling precautions -1, Checking model and specifications -1, Accessories -1, Storage precautions -1, 1 checking model and specifications

IM 01E20C02-01E
2-1
2. HANDLING PRECAUTIONS
2.
HANDLING PRECAUTIONS
This instrument has been inspected carefully at the
factory before shipment. When the instrument is
delivered, visually check that no damage has occurred
during transportation.
Read this section carefully as it contains important
information on handling this instrument. Refer to the
relevant sections for information not contained in this
section. If you have any problems or questions, please
contact Yokogawa sales office.
2.1 Checking Model and
Specifications
The model code and specifications are found on the
data plate located on the outside of the case. Check
that the model code and specifications match what you
have ordered.
Be sure you have your model number and serial
number available when contacting Yokogawa.
F0201.EPS
Figure 2.1.1 Data Plate
2.2 Accessories
Check that the parts shown below are included in the
package:
᭹ Mounting hardware: 1 set
᭹ Hexagonal wrench: 1 piece (nominal size 3 mm)
2.3 Storage Precautions
If the instrument is to be stored for a long period of
time after delivery, observe the following points.
᭹ The instrument should be stored in its original
packing condition in the storage location.
᭹ Select a storage location that fulfils the following
conditions:
• A place where it will not be exposed to rain or
water
• A place subject to minimal vibrations or shocks
• Temperature and humidity levels should be as
follows:
Temperature: -30 to 70
°C
Humidity: 5 to 80% RH (no condensation)
The preferred ambient temperature and
humidity levels are 25
°C and approximately
65% RH.
᭹ If the AXFA14 converter is transferred to the
installation site and stored without being installed,
its performance may be impaired due to the infiltra-
tion of rainwater and so forth. Be sure to install and
wire the AXFA14 as soon as possible after transfer-
ring it to the installation location.