Yokogawa AXFA14G/C - Manual (Page 28)

IM 01E20C02-01E 5-8
5. BASIC OPERATING PROCEDURES
When the switch is touched, the entire
display flashes on and off. Confirm that the setting
has been correctly changed to “120”, and then fix
this value by touching the switch once again.
NOTE
When no operations are carried out for 20
seconds in the flashing state, the system will
automatically return to the Sub-item Parameter
Search Mode.
When the operations except are carried
out, the parameter cannot be set.
The system automatically returns to sub-item
selection screen (B).
NOTE
If the input value is outside the valid selection
range, the message “Out of range. Touch any
key.” will be displayed. In such a case, touch
any switch to return to Parameter Replacement
Mode and redo the setting.
NOTE
If more than one decimal point has been input,
the message “Invalid value. Touch any key.”
will be displayed. In such a case, touch any
switch to return to Parameter Replacement
Mode and redo the setting.
5.3.3 Setting Example for Alphanumeric-Type Data: Tag number
This example describes the setting of the tag number for the alphanumeric-type parameter
C10: Tag No. from “FI-1101” to “FI-1201.”
Setting Mode Condition
Touch the switch to access C: Basic Setup.
NOTE
The
᭡ and ᭢ symbols to the left of the param-
eters indicate that additional setting items to
those being currently displayed may also be
selected. Use the
switch to cycle
through these items.
The cursor has been moved to C: Basic Setup in
this screen.
Touch the switch to enter C: Basic Setup.
F0505-2.EPS
Major item
Sub-item
selection (B)
Incorrect setting:
Incorrect setting:
Out of range.
Touch any key.
Invalid value.
Touch any key.
Sub-item
Parameter
Search Mode
B23:Flow Span
120 l/min
B:Easy Setup
22:Base Time Unit
23:Flow Span
24:Flow Decimal Pnt
B23:Flow Span
100 l/min
1200000 l/min
Rng:0.00001 32000
B23:Flow Span
100 l/min
0001.0. l/min
Rng:0.00001
32000
Setting Mode
P:Protect
B:Easy Setup
C:Basic Setup
Setting Mode
B:Easy Setup
C:Basic Setup
D:Total Set
F0506-1.EPS
Setting mode
Major item
parameter
Setting mode
Major item
parameter
Start:
Major Item
Parameter
Search Mode