IEI Integration WAFER-LX v1.22 - Manual (Page 119)

WAFER-LX Motherboard
Page 101
Î IDE HDD Block Mode [Enabled]
If the drive connected to the system supports block mode, use the IDE HDD Block Mode
option to enable the system to detect the optimal number of block read/writes per sector
the system IDE drive can support. Block mode is also called block transfer, multiple
commands, or multiple sector read/write.
Î
Disabled Block mode is not supported.
Î
Enabled D EFAULT Block mode is supported.
Î Onboard FDC Controller [Disabled]
Use the Onboard FDC Controller option to enable or disable the onboard floppy
controller. If the system is not connected to a floppy disk or uses an adapter for the FDD,
this option can be disabled.
Î
Disabled D EFAULT The FDD controller is disabled.
Î
Enabled The FDD controller is enabled.
Î Onboard Serial Port 1 [3F8/IRQ4]
Use the Onboard Serial Port 1 option to select the I/O address and IRQ for the onboard
serial port 1. The serial port can be disabled or the I/O address and the IRQ can be
automatically selected by the BIOS. The Onboard Serial Port 1 options are:
ƒ Disabled
ƒ 3F8/IRQ4 (Default)
ƒ 2F8/IRQ3
ƒ 3E8/IRQ4
ƒ 2E8/IRQ3
ƒ Auto
Î Onboard Serial Port 2 [2F8/IRQ3]
Use the Onboard Serial Port 2 option to select the I/O address and IRQ for the onboard
serial port 2. The serial port can be disabled or the I/O address and the IRQ can be
automatically selected by the BIOS. The Onboard Serial Port 2 options are: