IEI Integration WAFER-LX v1.22 - Manual (Page 115)

WAFER-LX Motherboard
Page 97
ƒ 1024 x 768
ƒ 1152 x 864
ƒ 1280 x 1024
ƒ 1600 x 1200
Î Data Bus Type [9 – 24 bits, 1 ppc]
The Data Bus Type option can only be configured if the Flat Panel Type option is not set
to Auto. Use the Data Bus Type option to set the bus type and the data bus width used to
transfer data between the system and the flat panel screen connected to the system. The
Data Bus Type options are:
ƒ 9-24 bits, 1 ppc (Default)
ƒ 18, 24 bits, 2 ppc
Î Refresh Rate [60Hz]
The Refresh Rate option can only be configured if the Flat Panel Type option is not set to
Auto. Use the Refresh Rate option to set the screen refresh rate required by the panel
connected to the system. Check the documentation that came with the panel before
setting this option. The Refresh Rate options are:
ƒ 60Hz (Default)
ƒ 70Hz
ƒ 72Hz
ƒ 75Hz
ƒ 85Hz
ƒ 90Hz
ƒ 100Hz
Î HSYNC Polarity [High]
The HSYNC Polarity option can only be configured if the Flat Panel Type option is not
set to Auto. Use the HSYNC Polarity option to set the polarity of the HSYNC signal to the
panel. The HSYNC Polarity options are:
ƒ High
ƒ Low (Default)