IEI Integration KINO-PV-D4252_D5252 - Manual (Page 65)

KINO-PV-D5252/D4252 Mini ITX SBC
Page 51
Figure 4-3: CompactFlash® Card Installation
4.6 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three
metal pins and a small metal clip (often
protected by a plastic cover) that slides over
the pins to connect them. To CLOSE/SHORT
a jumper means connecting the pins of the
jumper with the plastic clip and to OPEN a
jumper means removing the plastic clip from a
jumper.