IEI Integration PCIE-H610 - Manual (Page 69)

PCIE-H610 PICMG 1.3 CPU Card
Page 54
Step 3: Insert the cable connectors . Once the cable connectors are properly aligned
with the USB connectors on the PCIE-H610, connect the cable connectors to
the on-board connectors. See Figure 4-14.
Figure 4-14: Dual USB Cable Connection
Step 4: Attach the bracket to the chassis. The USB 2.0 connectors are attached to a
bracket. To secure the bracket to the chassis please refer to the installation
instructions that came with the chassis.
4.6 External Peripheral Interface Connection
This section describes connecting devices to the external connectors on the PCIE-H610.
4.6.1 LAN Connection
There are two external RJ-45 LAN connectors. The RJ-45 connectors enable connection
to an external network. To connect a LAN cable with an RJ-45 connector, please follow
the instructions below.