Vestil SWA-60-AW - Manual (Page 19)

F:\Manual\SM-1517R-110V-100514 14.05.2010. - 17 -
『
Midpoint Strengthen Wrapping
』
:
Film wraps from bottom to top and completes the upper layer wrapping cycle.
When returning from top back to bottom, film set will pause at the midpoint of
the package to complete 2 wrapping cycles and then back to bottom to
complete wrapping.
l ON 0 O F F
『Auto cut option』:
To choose the auto cut option.
TEL:886 4 533−6601 IT EM NO.
SM- AI R
0 O F F l ON
FAX:886 4 533−6776 PO WE R R V DA TE A Phase Hz W EIG HT K gs. ST RE TCH WRA PP IN G MA C HIN E Ta ic hun g H sie n, Tai wa n, R.O .C. SHI I M EEI I NDU STRI AL CO. , LT D. 26 , Sec . 1 , T a F u R oa d, Tan Tz u H sia ng , SERI ES NO. bar
『Non-auto cut option』:
To choose the non-auto cut option.
For SM-2517 & SM-2517R Use only
『Follower-Plate Fall Down Button』:
To lower the follower-plate, used in conjunction with the 『 Auto』&
『
Manual』buttons. When set at 『Auto』, press this button to lower
follower-plate onto package until tight, after which the follower-plate stops
lowering and turntable rotation starts. If set at 『Manual』, press this button to
lower follower-plate to stop lowering follower-plate. There is need to press
the Turntable 『Start』button to start turntable rotation when using 『Manual』
function..
『 Auto 』 Wrapping Modes Setting Key:
When this function is set the button will light up. Press the “Follower-plate
Down” button when this function is activated, the follower-plate will
automatically lower onto package until tight and turntable rotation will start.
When wrapping cycle is completed, the follower-plate will lift up again. No
need to press any other button.
『 Manual 』 Wrapping Modes Setting:
When this function is set, press the “Follower-plate Down” button to lower the
follower-plate and limit switch LS4 is touched to stop lowering. The turntable
will not start automatically, therefore press “Turntable Start” button to start
turntable rotation.