Vestil AF-xxxx - Manual

1
VESTIL MANUFACTURING COMPANY
2999 North Wayne St., Angola, IN 46703 USA
Phone (260) 665-7586 • Fax (260) 665-1339
E-mail: [email protected] • www.vestil.com
SAFETY PRECAUTIONS
Read owner's manual completely before operating unit!
• Never exceed the maximum capacity of 2,000 pounds.
• Load must be evenly distributed on platform to insure
stability.
• Always apply wheel brakes when unit is not being moved.
• Always operate unit on a level surface to insure stability.
• Use caution in moving a loaded unit; avoid obstructions
and floor defects.
• Remove weight and apply wheel brakes before removing
the top frame of the cart.
• Make sure all operator safety labels are in place (p.2).
RECEIVING INSTRUCTIONS
Every unit is thoroughly tested and inspected prior
to shipment. However, it is possible that the unit may incur
damage during transit. If damage is noticed when unloading,
make a note of it on the BILL OF LADING. Remove all
packing and strapping material, then inspect the unit again
for damage. IF DAMAGE IS EVIDENT, FILE A CLAIM WITH
THE CARRIER IMMEDIATELY!
WARRANTY
This product is warranted for 90 DAYS from date of
purchase to be free of manufacturing defects in material and
workmanship. The manufacturer's obligation hereunder is
limited to repairing such products during the warranty period,
provided the product is sent prepaid back to the factory.
This warranty does not cover normal wear of parts
or damage resulting from any of the following: negligent use
or misuse of the product, use or application contrary to
installation instructions, or disassembly, repair or alteration
by any person prior to authorization from a factory
representative.
A FRAME CART
MODEL AF-3048 & AF-3672
OWNER'S
MANUAL
Revised 03-03 16-126-103
A company dedicated to solving ergonomic and material
handling problems since 1955.
A-FRAME CART
MODEL AF-3048 & AF-3672
Ergonomic Solutions
Contents
Safety Precautions ....................................... 1
Receiving Instructions .................................. 1
Warranty ....................................................... 1
Assembly Instructions .................................. 1
Assembly & Parts Drawing ........................... 2
Parts List ....................................................... 2
Warning Label Identification ......................... 2
ASSEMBLY INSTRUCTIONS
TO INSTALL UPPER PORTION OF CART
Position pieces as shown on drawing, see page 2. Install
bolts and nuts, tighten finger tight. Once all the pieces are
losely bolted together tighten nut & bolt combo's.
TO INSTALL THE CASTERS
Two rigid casters are installed on one end of base frame and
two swivel casters at the other end.
1.) Place caster base plate into caster pad bracket.
2.) Insert 3/8"-16 UNC x 5" carriage bolt through the
square hole in caster pad to hold caster in place.
(Make sure head of carriage bolts towards outside
of cart).
3.) Place 3/8"-16 UNC locknut on each bolt and tighten
securely.
(Please refer to the next page for the assembly drawing)
E
S
P
A
N
O
L
E
N
G
L
I
S
H