Vestil SWA-60-AW - Manual (Page 18)

F:\Manual\SM-1517R-110V-100514 14.05.2010. - 16 -
5-2 Wrapping Function Control
『Turntable Start』:
Starts the turntable rotation, motor will stop automatically when wrapping is
completed.
『Film-Seat Pause Button』:
When wrapping a particular section of the package that needs extra overlapping
of film to give strength, press and hold this button for the film-seat to pause at
the desired section of overlapping. When the operator is satisfied with the
amount of overlapping, release this button and the film-seat will continue its
ascending/descending.
『Turntable and Film-seat Zero-return Button』:
This button has two functions:
1: It can be used to determine the height of package in case of malfunctioning
of the electronic eye. When electronic eye malfunctions, the film-seat can not
sense the height of the package and will continue to ascend, in which case by
pressing this button the film-seat will cease ascending and start counting number
of upper layer wrapping cycles. Also press this button if the film wrapping
reaches a particular height of the package and further more wrapping above is
not desired.
2: If the emergency button is activated during wrapping, the turntable and the
film-seat will not be stopped at the starting position. Therefore in order for both
the turntable and the film-seat to return to their starting position, press this
button once for turntable to return to starting position and press again for
film-seat to return to starting position.
『
Standard Wrapping
』
:
Film starts wrapping from the bottom of the package to the top, and once from
top back to bottom。
『
Single Layer Wrapping
』
:
Film wraps once from bottom to top and stops when turntable comes to a halt.
Film set then automatically descends down to starting point.
『
Water Proof Wrapping
』
:
Film wraps from bottom to top and then comes to a halt at
approximately 10cm~15cm below the top of the package, then a sheet of water
proofing film or plastic should be manually placed on top of the package. Press
the Turntable Start button once more to restart the wrapping process, at which
the film will start wrapping from top back to bottom.