Teledyne LeCroy PETracer Summit and Summit T2-16 PCIe User Manual - Manual (Page 22)

Chapter 2: Hardware Description Summit User Manual
14
Teledyne LeCroy
LCD Menus
The PETracer Summit has a front LCD panel that displays menus with commands for
configuring the device.
Boot Sequence
The boot sequence for the Summit box takes a few seconds. As the box boots, it
initializes itself, beeps, and shows the status on the LCD panel. If the box boots
successfully, the LCD panel Root menu appears.
During initialization, the LCD panel displays boot status messages.
Booting from Boot-Code
If the Summit box does not boot successfully, or if it becomes non-responsive, you can
boot from default settings called boot-code.
Boot-code is a simplified version of Summit firmware. It allows the box to boot to the point
where it can communicate with the Summit software application. After communication is
established between the box and software application, you can download a different
version of firmware and BusEngine files to the box.
To boot from boot-code:
Step 1 Press and hold the Manual Trigger button on the Summit box front
panel.
Step 2 While holding the button DOWN, turn the box ON.
After you complete these steps, download the new version of BusEngine and firmware
files, then reboot the box from the LCD panel menu (Summit Setup > Reboot).
Root Menu
The Root menu appears after successful boot-up. The top line of the Root menu displays
the device status with the following:
• [PCI]: Indicates the hardware platform.
• Idle: Shows analyzer status.
Submenus
The Root menu has these options:
• Summit Setup menu: Allows setup using submenus.
• Platform Status menu: Shows the results for the power-on self-diagnostics.
Note: When lists of options are presented in a menu, the current selections are
indicated with an asterisk.
To navigate, use the Up Arrow and Down Arrow buttons (top and bottom blue buttons)
on the front of the unit.
To select or change an option, use the Select button (middle blue button).