Teledyne LeCroy PETracer Summit and Summit T2-16 PCIe User Manual - Manual (Page 20)

Chapter 2: Hardware Description Summit User Manual
12
Teledyne LeCroy
Summit T2-16 Setup Menu
Menu Submenu Command
IP Mode Static
Dynamic Static = You assign an IP address. 
Dynamic = A DHCP server assigns an IP address.
IP Address If IP Mode = Dynamic, this field is ignored.
Subnet Mask Default is 0.0.0.0 
If IP Mode = Dynamic, this field is ignored.
Default Gateway Default is 0.0.0.0 
If IP Mode = Dynamic, this field is ignored.
Reboot Cancel
Confirm Selecting Confirm causes Summit to save the
current configuration and reboot.
Shutdown Cancel
Confirm Selecting Confirm causes Summit to save the
current configuration and shut down.
About Displays status on the following parameters:
• Subnet Mask
• Default Gateway
• BootCode
• Firmware
• Bus Engine
• IP Mode: Dynamic or Static
Note: To go back to the previous menu, press the
Select button (middle button).
[Back] Returns to the Root menu.