Staub Electronics B-500-MTRX-230-8X8 BINARY - HDMI 8X8 MATRIX SWITCH WITH HDMI AND HDBASET OUTPUTS User Manual

Page 18

B-500-MTRX-230-8x8 Installation Manual

Pg. 18

™

8.4.2. How to Set Embedded EDID for a Single Input

8.5.1. How to Learn EDID to a Single Input

8.4.3. How to Set Embedded EDID for All Inputs

Example: Input =1 Embedded EDID=4

Display Readout (Example)

1. Press DEFAULT

E-

2. Press Number Key (1-8) to select one Embedded EDID

3. Press INPUT

4. Press Number Key (1-8) to select the Input to which the EDID

is applied

5. Press ENTER

(success)

(fail)

Example: Input =1 Embedded EDID=4

Display Readout (Example)

1. Press DEFAULT

E-

2. Press ALL to select all Inputs

A-

3. Press Number Key (1-8) to select Embedded EDID

4. Press ENTER

(success)

(fail)

8.5. EDID Learning

For more advanced EDID configuration, learning can be used to assign EDIDs directly from displays to one or more

inputs. This is useful when the system contains a display that cannot accept the highest resolution available from

sources, but all sources need to be available to all displays.

Note: EDIDs can be learned from displays connected via the HDBaseT or the HDMI output.
When to Use Learned EDIDs
• An older display does not work properly with any of the embedded EDIDs.
• When the source is a PC it may be necessary to use a learned EDID.
• Learning EDID to a single input

Example: Input =1 EDID Learned from Output 4

Display Readout (Example)

1. Press LEARN once for HDMI port or twice for HDBaseT

port

2. Press OUTPUT

3. Press Number key (1-8) to select the Output the EDID

is learned from

4. Press INPUT

L-

5. Press Number Key (1-8) to select the Input to which the

EDID is applied

6. Press ENTER

(success)

(fail)