Staub Electronics SM-CEILING-T-L STRONG - LARGE CEILING MOUNT FOR 36-60 FLAT PANEL DISPLAYS User Manual
Sm-ceiling-t-l sm-ceiling-dt-l
Lifetime Limited Warranty
Strong™ Mounts have a Lifetime Limited Warranty. This warranty includes parts and labor repairs on all components
found to be defective in material or workmanship under normal conditions of use. This warranty shall not apply to prod-
ucts which have been abused, modified or disassembled. Products to be repaired under this warranty must be returned
to SnapAV or a designated service center with prior notification and an assigned return authorization number (RA).
For Technical Support call 1.866.838.5052
Lifetime
100823
SM-CEILING-T-L
SM-CEILING-DT-L
Strong™ Large Ceiling Mount and Dual Ceiling Mount
for 36-60 in. Flat Panel TVs (Black)
c. Re-install washer and bolt onto end of bolt and tighten down using a 7/16”
socket head wrench until secure (per instructions with wall anchor).
WARNING: Tighten nuts so that ceiling plate is firmly attached,
but do not over tighten. Over tightening can damage
the bolts, greatly reducing their holding strength.
d. Install Ceiling Plate Covers over ends of
Ceiling Plate (optional).
Step 3: Attach the Mount Head
a. Attach Wall Plate onto Mount Head by inserting
through-bolts on Wall Plate through angled slots
in Mounting Head. Place M8 Washers and Nylock
Nuts on end of through bolts and tighten down (Fig 3).
b. Screw Mount Head on to end of extension pole
and tighten set screws.
Step 4: Attach the TV Arms to the Display
a. Attach the TV Arms to the display using
M4, M5, M6, or M8 screws. For displays
with a hole pattern in a pocket or inputs
behind TV Arms, spacers go between
TV Arms and display (Fig 4).
Step 5: Attaching the TV Arms with
Display to Ceiling Mount Assembly
a. Place TV Arms with Display onto Wall Plate and
tighten security screws at the bottom of each
TV Arm and insert Locking Pin to hold tilt (Fig 5).
ADJUSTMENTS
Adjust Tilt and Horizontal Level
Tilt Adjustment
a. Loosen screws on side of mount head. (Only enough
to allow controlled adjustment)
b. Adjust Tilt
c. Tighten screws on side of mount head to hold tilt.
Horizontal Level Adjustment (Roll)
a. Slightly loosen all 4 Nylock Nuts behind Wall Plate only to allow movement
of wall plate. Using the corners of the TV, adjust left/right until level.
Re-tighten all Nylock Nuts. WARNING: Completely loosening and/or
removing nuts may cause plate and/or TV to fall causing serious injury.
Fig 3
Fig 4
Fig 5