Staub Electronics SM-RAZOR-M STRONG - MEDIUM FIXED ZERO CLEARANCE MOUNT FOR 23-46 - Manual

Lifetime Limited Warranty
Strong™ Mounts have a Lifetime Limited Warranty. This warranty includes parts and labor repairs on all components found to be defective
in material or workmanship under normal conditions of use. This warranty shall not apply to products which have been abused, modified or
disassembled. Products to be repaired under this warranty must be returned to SnapAV or a designated service center with prior notification
and an assigned return authorization number (RA).
For Technical Support call 1.866.838.5052
Lifetime
INSTRUCTION MANUAL
SM-RAZOR-M/ SM-RAZOR-L
Strong™ Zero-Clearance Fixed Mount
for Ultra-Thin TV’s (Black)
b. Insert four Lag Screws (C) into the Wall Anchors
through the Wall Plate. Tighten all bolts with
Allen Key (S).
WARNING: Tighten bolts so that wall plate is firmly
attached, but do not overtighten. Overtightening
can damage the bolts, greatly reducing their
holding strength.
Step 2: Mount Arms to television
a. Determine the diameter of the screw (parts G through
O) your TV requires by carefully trying to hand-thread
one into the threaded insert on the rear of the TV.
If there is any resistance, stop immediately.
b. Spacers are commonly needed on televisions with
curved backs or recessed screw inserts. The screw
will thread through the appropriate washer (P),
any spacer needed (F) and the arms into the TV.
c. Ensure the arms are installed flat side to television and
are square to each other after all screws have been
installed (Figure 5).
Step 3: Hang television on to the Wall Plate
a. Carefully lift the television and place arm hooks over
and onto angled lip in Wall Plate (Figure 7). Do not
release the television until it is completely connected
to the Wall Plate.
Figure 5
Figure 6
Figure 7