Staub Electronics SM-CS-ART2-L STRONG - CONTRACTOR SERIES ARTICULATING MOUNT FOR 42 - 63 FLAT PANEL TVS User Manual
Sm-cs-art2-l, Instruction manual, Mounting head tilt levers
Step 4 : Mounting the Assembled Adapter
Plate to Screen
Modify the Assembled Adapter Plate
Slide the Adapter Brackets onto Assembled Adapter
Plate rods. Place the assembled Adapter Plate on the
back of the display with one Adapter Bracket aligned
with a set of vertical mounting holes. Then, slide the
other Adapter Bracket in or out until it aligns with the
second set of vertical mounting holes. The Adapter Plate
should be horizontally centered on the back of the flat
panel display.
Use four M6x12 screws and four metal washers and tighten
Adapter Brackets to Adapter Plate rods with a Phillips Head
Screw Driver.
NOTE: There are eight positions for flexibility. Move
the Adapter Brackets to desired location. Adapter
Brackets can be flipped around (if required).
Attach the Adapter Brackets using four mounting screws
and four square washers (size will depend on thread pat-
tern on flat panel being installed). Once aligned, tighten
all screws down with a Phillips Head Screw Driver.
Insert two M8 Hex head screws on the top of the Adapter
Plate with the M6 Allen Wrench.
DO NOT IMMEDIATELY
TIGHTEN DOWN!
Step 5: Attaching Screen to Wall Arm Assembly
Lift the display and hook the two Hex head screws with
metal washers in grooves on top of the Mounting Head.
Insert two more Hex head screws with washers in bot-
tom two holes of the Mounting Head, securing it to the
Adapter Plate. Then tighten all four screws with the
Allen Wrench.
NOTE: For demonstration purposes, the wall has been
omitted from the illustrations.
NOTE: This procedure will require two persons.
Ensure that the arm is set to its maximum negative
tilt prior to attaching the display.
Step 6: Running Cables
Run as shown and install Wire Management Caps.
NOTE: Make sure cords have enough slack to allow
full movement of the arm.
Mounting
Head
Tilt Levers
M8 Hex head
screws w/washers
Adapter
Plate
Back of
Display
Adapter
Bracket
Metal Washer
(6 x 13 x 1.2)
M6 x 12
Screw
Mounting
Screw
Square
Washer
M8 Hex head
screws w/washers
Wire Management
Caps
SM-CS-ART2-L
Strong™ Contractor Series Universal
Articulating Mount With Dual Arms
For Large Displays
INSTRUCTION MANUAL
Lifetime Limited Warranty
Strong™ Mounts have a Lifetime Limited Warranty. This warranty
includes parts and labor repairs on all components found to be
defective in material or workmanship under normal conditions of
use. This warranty shall not apply to products which have been
abused, modified or disassembled. Products to be repaired under
this warranty must be returned to Snap AV or a designated service
center with prior notification and an assigned return authorization
number (RA).
For customer assistance call 1.866.838.5052
Lifetime