Staub Electronics SM-CEILING-SCA-WH STRONG - SUSPENDED CEILING TILE ADAPTER PLATE - Manual

Lifetime Limited Warranty
Strong™ Mounts have a Lifetime Limited Warranty. This warranty includes parts and labor repairs on all components
found to be defective in material or workmanship under normal conditions of use. This warranty shall not apply to prod-
ucts which have been abused, modified or disassembled. Products to be repaired under this warranty must be returned
to SnapAV or a designated service center with prior notification and an assigned return authorization number (RA).
For Technical Support call 1.866.838.5052
Lifetime
100823
SM-CEILING-SCA-WH
Strong™ Suspended Ceiling Tile Adapter Plate (White)
Fully insert eye bolts (Fig 4).
Solid Concrete:
Drill 1/4” (6 mm) diameter
holes 1.5” (38 mm) deep.
Hammer in Concrete Anchors (Fig 5).
Truss Ceiling:
No anchor required. After attaching
Tie Wire to Turnbuckle, loop upper end
around ceiling truss. Pull Tie Wire tight
and twist it around itself several times
(minimum of 6-8 times recommended)
as tightly as possible (Fig 6).
Position the holes so when the Tie Wires are
attached and taut, the optimal angle is 15°.
Unit may be mounted at an angle up to
45° if necessary.
e. Pull Tie Wires tight and attach to ends of ceiling anchors. Twist each wire around
itself several times (minimum of 6-8 times recommended) as tightly as possible.
The weight of the Ceiling Tray should be supported by the Tie Wires.
Note: 20’ (6.1 m) of Tie Wire is provided. If space between the true ceiling and
suspended ceiling is more than 36” (914 mm), additional wire (12 gauge annealed,
steel, black) will be needed.
DO NOT extend two wires together - use one continuous wire.
Step 4: Install Extension Pole (optional)
a. If installed, remove the Flush Mount Tube.
b. From the bottom up, thread Extension Column (not included)
up through Retaining Collar in Adjustable Collar Mount Plate.
Fasten with a Set Screw using the Allen Wrench (Fig 7).
Fig 6
Fig 7
Fig 5