Staub Electronics SM-ART1-M STRONG - ARTICULATING MOUNT FOR 22 - 40 FLAT PANEL TVS - Manual

Lifetime Limited Warranty
Strong™ Mounts have a Lifetime Limited Warranty. This warranty includes parts and labor repairs on all components
found to be defective in material or workmanship under normal conditions of use. This warranty shall not apply to prod-
ucts which have been abused, modified or disassembled. Products to be repaired under this warranty must be returned
to SnapAV or a designated service center with prior notification and an assigned return authorization number (RA).
For Technical Support call 1.866.838.5052
Lifetime
100823
SM-ART1-M
Strong™ Medium Single-arm Articulating Mount
for 22-40 in. Displays (Black)
Step 3: Attaching the Adapter Plate
to the Display
a. Attach the Adapter Plate to the display using
M4, M5, M6, or M8 screws. For displays with
a hole pattern in a pocket or inputs behind
Adapter Plate, spacers go between Adapter
Plate and display (Fig 3).
Step 4: Attaching the Adapter Plate with
Display to Wall Arm Assembly
a. Attach Adapter Plate and Display onto
Wall Arm Assembly, ensuring all 3 hooks
slide into holes of Mounting Head (Fig 4).
b. Using a Philips Head Screwdriver, tighten
down Locking Screw located on Adapter
Plate into threaded hole in the Mounting
Head on Wall Arm Assembly.
ADJUSTMENTS
Adjust Tilt and Horizontal Level
Tilt Adjustment
a. Loosen Tilt Lever (Only enough to allow controlled adjustment)
b. Adjust Tilt
c. Lock Tilt Lever (Tighten)
d. Once Tilt Lever is locked, the position of the lever can be adjusted,
without loosening or tightening the unit, by pulling the lever outwards
and then repositioning it to a vertical, less obtrusive position.
Horizontal Level Adjustment (Roll)
a. To adjust the horizontal angle (roll) of the display,
use the screws found on the back side of Wall Arm
Assembly Mounting Head. First remove the inset
Philips head screw on the left of the mount arm (Fig 5).
Next, slightly loosen the top two screws then firmly
hold opposite corners of the display and gently turn
it into the desired position. When level, re-tighten
top screws to lock in the position.
OTHER FEATURES
Cable Management
a. Pass through locations in arms allow for Wire Ties to be inserted to manage wires,
if needed.
Fig 4
Fig 5
Fig 3
Inset screw,
to be removed first