KB Electronics KBDF-48 User Manual
Page 18
18
7 MOUNTING INSTRUCTIONS
It is recommended that the drive be mounted vertically on a flat surface with adequate
ventilation. Leave enough room above and below the drive to allow for AC Line, motor
connections, and any other connections that are required. Care should be taken to avoid
extreme hazardous locations where physical damage can occur. When mounting the drive in an
enclosure, the enclosure should be large enough to allow proper heat dissipation so that the
ambient temperature does not exceed 40 °C (104 °F) at full rating. See Figure 4, below, and
Figure 5, on page 19.
WARNING! DO NOT USE THIS DRIVE IN AN EXPLOSIVE ENVIRONMENT. AN
EXPLOSION CAN CAUSE SERIOUS OR FATAL INJURY. THIS DRIVE IS NOT EXPLOSION
PROOF.
FIGURE 4
CASE "A" DRIVES MECHANICAL SPECIFICATIONS (INCHES / mm)
7.25
184
KBDF SERIES
71.1
2.80
86.4
3.40
6.785
172
5.10
130
REV
FWD
STOP
RUN
0.225
5.72
4X Ш