IAI America IA-T-XD - Manual (Page 91)

12. Program Edit
82
3?C
Display “Num” in the F1 key area.
Input the numerical value by using the 10 keys.
The diagram on the left is an example for inputting
“1.”
After finishing the comment input, press the return
key again.
Transmit the input data to the controller by pressing
the WRT key.
* If you change the screen with the PAGE UP ·
PAGE DOWN or ESC keys before transmitting the
data, the input data will be invalid.
The screen moves to the next step No.
To finish the program input, return to the Flash Rom writing screen by using the ESC key.
Note: Full size character data input by the PC software can’t be displayed on the teaching
pendant.
83
#$& @?+.@F@@C
The following operating instructions are to copy or move a program to another program No.
Select the F1 (Edit) key on the mode selection
screen.
Select the F2 (Prog) key.
Select the F2 (Copy) key.
Input the program No. from which a program is
copied or moved by using the 10 keys and press the
return key.
Input the program No. to which a program is copied
or moved by using the 10 keys and press the return
key.
To copy the program, press the F2 (Copy) key. To
move the program, press the F3 (Move) key.
Return to the previous screen with the ESC key.
Furthermore, press the ESC key several times and
return to the Flash ROM writing screen.
Program No. from which a
program is copied or moved
Program No. to which a
program is copied or moved