IAI America IA-T-XD - Manual (Page 89)

12. Program Edit
80
The 10 keys become alphabet inputs. Input
“TAIKIITI.”
For the input procedure, please refer to the section
“13. Symbol Edit.”
Transmit the symbol data to the controller by
pressing the WRT key. Return to the edit screen.
The teaching pendant can’t display symbols as
inputs. In this case, display “S10” instead of
“TAIKIITI.”
In the state where the cursor is located in the
symbolized section, if F2 (Sym) key is chosen, it will
move to the symbol edit screen. The symbol can
then be changed.
Transmit the data of this program step to the
controller by pressing the WRT key.
The letter, S indicates
symbol is used.
Definition value of
Symbol
To finish the program input, return to the Flash ROM writing screen by using the ESC key.
81
#$% .@??3
Turns a step from a program into a comment (invalid step) and you can input numbers, alphabets
and signs (* · _).
Mode Transition: Program No. return
Move the cursor to the step No. for comment input.
Press the F3 (Cmnt) key.
“C” will be displayed after the step No.
Press the return key.
Each time you press the F1 key, the display of the
F1 key area switches from “Alph” to ‘Num’.
,;
Display “Alph” in the F1 key area.
Alphabets are allocated to each of the 10 keys.
Ex) Each time you press 6, display changes Po Qo
RopoqoroPo ..... Display the alphabet you’d like
to input and press the return key. The example of the
left displays “P.”
On the left is an example for inputting the word
“Palette.”